|
Motion Mind Connector Board
|
|
Serial / Analogue / Button / R/C position or speed
controller
|
|
- 6-36VDC Brush Motor
- 9A continuous, 25A peak
- RS232 / TTL, ASCII / Binary communication
- 2.4" x 3.6" footprint
- Quadrature encoder interface
|
|
|
| The Motion Mind Connector Board simplifies connecting
to the Motion Mind for testing. A DB9 female connector
as well as ribbon cable and 20 pin shrouded connector are shipped
with this custom PCB. The components come as a kit that must be
assembled; soldering is therefore required. You can solder these
components to the PCB and solder to specific wiring points associated
with the 20 pin connection to your test setup. The custom PCB is
slotted to allow access to the motor terminal block connections.
An RS485 IC footprint is included for use with the Motion Mind hardware.
2" fan mounting holes are also included.
|
|
|
|
|
