A
power supply which has been specifically designed for use
with the TC35i Terminal,
MC35i Terminal or
TC65 Terminal. The output cable
is terminated with an RJ11 plug which connects directly
to your modem. An AC Cable is included to connect to your
local mains supply.
input: 100-240V AC, 50-60Hz
output: 12V DC @ 2.5A
Note: Only AC Cables fitted
with a UK or European type plug are available. The appropriate
AC Cable will be sent with your order as determined by your
delivery address.
This
cable allows you to easily connect a power supply to your
TC35i Terminal,
MC35i Terminal or
TC65 Terminal. The cable is
terminated with an RJ11 plug at the modem end and is unterminated
at the power supply end.
The unterminated end of the Siemens
Terminal Power Cable must be connected to your power supply
as follows:
Signal
Wire Colour
Description
Power Supply
+
Black
Positive supply
+V
IGT_IN
Blue
Ignition input
+V (optional)*
GND
Orange
Ground
GND
* IGT_IN may be permanently connected to + (black and
blue wires tied together) to ensure that the terminal is
immediately switched to the active state when power is applied.
300mm
cable for connecting the I/O port of your
TC65 Terminal to the outside
world. The cable is terminated with a 24 pin Micro-N-Lok
connector at the modem end and is unterminated at the other
end.
Adapter for use with our TC65
Terminal which coverts the terminal's SMA type antenna connector
to an FME type connector allowing any one of our FME terminated
GSM antennas to be used with the TC65 Terminal. Please note
that this item is included in our Siemens TC65 Terminal
Starter Kit.
Solar
A
power supply which has been specifically designed for use
with the 
This
cable allows you to easily connect a power supply to your
2.0m
long, 9-pin cable to connect the serial port of your
TC65 Terminal I/O
Cable 
300mm
cable for connecting the I/O port of your
